CZ P-10 red dot mounts

CZ P-10 red dot mounts replace the rear sight with a model-specific dovetail plate so you can run a red dot on non-Optics Ready P-10 slides—no milling and fully reversible.

Why choose a mount on the P-10?

• Keep the slide uncut: add an optic without permanent machining or refinish work.
• Prove the setup first: try different dots/positions, then swap back to irons in minutes.
• EDC aware: compact optics and low-profile mounts help preserve holster fit and balance.

Footprints commonly supported

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install checklist

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; recheck after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Have a P-10 Optics Ready?

OR slides use plates for a lower, more rigid interface—see Optics Ready plates.