CZ 75 SP-01 Kadet red dot mounts

View as
CZ Shadow 2 Kadet, CZ 75 SP-01 Kadet, CZ 75 Kadet red dot mount universal | type C Outer Impact

CZ 75 SP-01 Kadet red dot mounts

CZ 75 SP-01 Kadet red dot mounts let you run a red dot on the SP-01 Kadet .22 LR slide by replacing the rear sight in the dovetail—no milling and fully reversible.

Why mount a dot on the SP-01 Kadet?

  • Cheap practice, same presentation: mirror your SP-01 match/carry dot on .22 for high-volume reps.
  • No permanent mods: keep the slide original and swap back to irons in minutes.
  • Cycle-friendly choices: lightweight, compact optics tend to run best on .22 slides.

Footprints commonly supported

  • Trijicon RMR footprint
  • Shield RMSc footprint
  • Holosun K-series footprint
  • Leupold DPP footprint
  • C-More RTS footprint
  • Vortex Venom / Docter footprint
  • Aimpoint ACRO footprint

Install checklist

  • Degrease interfaces and screws; apply Loctite threadlocker.
  • Torque to spec for mount-to-slide and optic-to-mount screws; re-check after the first range session.
  • Verify screw length & pitch so nothing protrudes into the slide channel.

Model notes

This page is for the CZ 75 SP-01 Kadet .22 conversion. If your centerfire SP-01 slide is Optics Ready, use Optics Ready plates for a lower, more rigid interface. For other non-OR CZs, see all dovetail red dot mounts.

Compare /3