CZ TS 2 Deep Bronze red dot mounts

CZ TS 2 Deep Bronze red dot mounts let you add an optic by replacing the rear sight in the dovetail—no milling, no permanent mods, and fully reversible.

Why this route on Deep Bronze?

• Keep the finish intact: upgrade without cutting the slide.
• Test & tune: try different optics/positions before committing to another slide.
• Easy revert: return to irons in minutes for rules, carry, or resale.

Supported footprints

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom / Docter footprint
• Aimpoint ACRO footprint

Install checklist

• Degrease interfaces and screws; apply Loctite threadlocker.
• Torque to spec for mount-to-slide and optic-to-mount screws; re-check after your first range session.
• Verify screw length & pitch so nothing protrudes into the slide channel.

Using an Optics Ready TS 2?

OR slides use plates for a lower, more rigid interface—see Optics Ready plates.